xxsaint69x

Built by PROLINE RACING back in 2007.
Only 6k miles on it, great oil pressure, everything looks good!
SOLD


Block: Stock LT1
Crank: Callies DragonSlayer - Stroke: 3.750
- Main Journal Size: 2.449
- Rod Journal Size: 2.100
- Bob Weight: 1888 Internal
Rods: Oliver Forged I beams - Length: 6.00
Pistons: Diamond w/upgraded pins
- Pin Size: .927
- Diameter: 4.040
- Compression Height: 1.125
- Dome/Dish: -31cc
Main Bearings: MS 909 HXK
Main Clearance: .0024
Rod Bearings: CB 663HK
Rod Clearance: .0021
Rings: Total Seal TNT 1/16 1/16 3/16
Top Gap: 26
2nd Gap: 22
Deck Height: -.006
Block Height: 9.000
Torque Main: 70 w/ moly / 60ft.lbs.
Torque Rod: 70ft.lbs w/ moly


after a quick wipe down with a rag and wd40...nice and clean







here is a old pic of the inside.

dennis5374

What kind of compression could I get out of this with a set of le2's with 52 cc chambers? Also how much would this be too ship? I've never shipped an engine before.

xxsaint69x

around 9.4 with a .042 gasket, shipping would be around 150 dollars by freight.

cino

This is exactly what I was looking for in spring.
Bump for a nice engine!

xxsaint69x

Thanks! At the rate things are selling ill probably still have it hehe

Sent from my DROIDX using Tapatalk

xxsaint69x

Make offers?

Sent from my DROIDX using Tapatalk