What the Heck!
#1
What the Heck!
Just came back from my body shop where my '84 Z28 is restored,
i ordered 2 quarter panel (jobber by my Car Quest dealer) and the one on the driver side won't fit at all, the hole for the gas tank is 1/2 inch too low. Any ideas what's wrong, my bodyman says that under the quarter panel, it's factory unrestored.....
Right now i have just ordered 2 Original GM Quarter Panel from WOODSTOCK, 769$ canadian each!!!
Cannot let my car have one side quarter jobber and the other side original....
What you think guys, do i put jobber front fender on my car or put Original Gm since my quarters will be original??? perhaps you can se a diffrence when mixing jobber body part with original GM.
I just want the curves on my fender and quarter panel to be exactly the same, plan to do some showroom with my car.
Can wait to hear from you guys.... I really dont care if it will cost me 2000$ more.....
i ordered 2 quarter panel (jobber by my Car Quest dealer) and the one on the driver side won't fit at all, the hole for the gas tank is 1/2 inch too low. Any ideas what's wrong, my bodyman says that under the quarter panel, it's factory unrestored.....
Right now i have just ordered 2 Original GM Quarter Panel from WOODSTOCK, 769$ canadian each!!!
Cannot let my car have one side quarter jobber and the other side original....
What you think guys, do i put jobber front fender on my car or put Original Gm since my quarters will be original??? perhaps you can se a diffrence when mixing jobber body part with original GM.
I just want the curves on my fender and quarter panel to be exactly the same, plan to do some showroom with my car.
Can wait to hear from you guys.... I really dont care if it will cost me 2000$ more.....
#2
Thread
Thread Starter
Forum
Replies
Last Post
Noct
General 1967-2002 F-Body Tech
6
07-07-2015 10:27 PM
cmsmith
2010 - 2015 Camaro News, Sightings, Pictures, and Multimedia
0
03-16-2015 02:34 PM