Custom gauge pod / black alcantara, Dyno-tune gauges, PICS
#1
Custom gauge pod / black alcantara, Dyno-tune gauges, PICS
I've been waiting quite awhile to install this triple gauge pod. Originally just did my A-pillars in the factory charcoal grey and then decided to do some custom work to the pillars and other components. I had both A-pillars done in Black Alcantara. I don't know how well the pics will show the quality of material and work, but it looks stellar in person !! I also had a chance to properly loom all the wiring with carbon flex for my gauges. Top gauge is the wideband O2, middle is N2O pressure, and bottom is Nitrous switch center. All three pillar gauges are Dyno-Tune units with the aluminum bezel ring. A/C vent pod gauge is the Aeroforce interceptor unit. Here's the pics, enjoy
PS: I will be updating some other items in the interior that have been custom covered in Black Alcantara w/red chain stitch. I plan on another round of upgrades next weekend.
PS: I will be updating some other items in the interior that have been custom covered in Black Alcantara w/red chain stitch. I plan on another round of upgrades next weekend.
#3
Thanks!!
I don't really want to say, it was salty for all the custom pod work and then the custom alcantara. If you really want to know the details, PM me
I don't really want to say, it was salty for all the custom pod work and then the custom alcantara. If you really want to know the details, PM me
Last edited by 96SilverRam; 07-05-2010 at 12:40 AM.
#5
Looks like some quality work. It looks good. Personally, I prefer painted or vinyl parts in those areas, because so much dust collects on the dash and interior parts. It can be tough to get looking good again after a while.
Thread
Thread Starter
Forum
Replies
Last Post
99TransAmWS6
Parts For Sale
2
02-12-2015 07:23 PM
Rich_z28
Car Audio and Electronics
3
08-29-2002 10:44 PM