Interface Cable problem
#1
Interface Cable problem
I've had a WOT Electronics serial to ALDL interface cable for a few years now and up until resently it worked fine.
When I run ALDL_TEST Version 2.0.0 created by TTS Power Systems, it passes 2 of the 3 phases.
It continues to fail the RTS portion of the test.
Here is the log:
Executing Extended Test procedure
Setting Baud to 8192:
>>Baud set to 8192
Beginning Phase1 COM test:
-->Enabling DTR only power...
-->Sending Test Data...
>>DTR Power Phase1 Test Passed
Beginning Phase2 COM test:
-->Enabling RTS only power...
-->Sending Test Data...
>>Timeout error receiving data, Phase2 failed
Beginning Phase3 COM test:
-->Enabling RTS + DTS power...
-->Sending Test Data...
>>DTR Power Phase3 Test Passed
Fast Test complete, errors occurred
Anyone have any idea how I might be able to troubleshoot this issue?
When I run ALDL_TEST Version 2.0.0 created by TTS Power Systems, it passes 2 of the 3 phases.
It continues to fail the RTS portion of the test.
Here is the log:
Executing Extended Test procedure
Setting Baud to 8192:
>>Baud set to 8192
Beginning Phase1 COM test:
-->Enabling DTR only power...
-->Sending Test Data...
>>DTR Power Phase1 Test Passed
Beginning Phase2 COM test:
-->Enabling RTS only power...
-->Sending Test Data...
>>Timeout error receiving data, Phase2 failed
Beginning Phase3 COM test:
-->Enabling RTS + DTS power...
-->Sending Test Data...
>>DTR Power Phase3 Test Passed
Fast Test complete, errors occurred
Anyone have any idea how I might be able to troubleshoot this issue?
Thread
Thread Starter
Forum
Replies
Last Post
Oncomingstorm22
General 1967-2002 F-Body Tech
4
01-22-2015 07:15 PM
Sarahrope64
LT1 Based Engine Tech
0
11-27-2014 11:17 AM