protoype 4" elbow
#31
Re: protoype 4" elbow
from looking at your pics the one you have possibly would work. i just cannot tell if the vortec sits higher than the procharger. if it does then the elbow will problly hit the sterring rack.
#32
Re: protoype 4" elbow
Originally Posted by JZ28Max
from looking at your pics the one you have possibly would work. i just cannot tell if the vortec sits higher than the procharger. if it does then the elbow will problly hit the sterring rack.
You will have to take pics..and show me
#33
Re: protoype 4" elbow
Originally Posted by CALL911
Thats for the LS1 setup. "No", it won't work for an LT1.
As for whoever put the screen on the inlet side of the blower. I am certain you will have little restriction, and it would block medium pebbles, and leaves from getting in there, but without an air filter, there will be nothing to stop dust and dirt from getting into your system. If you only track your car, this may be ideal. But for people like me who mostly drive it on the street, I would reccomend getting an air filter attached somehow to the intake side of the blower.
As for whoever put the screen on the inlet side of the blower. I am certain you will have little restriction, and it would block medium pebbles, and leaves from getting in there, but without an air filter, there will be nothing to stop dust and dirt from getting into your system. If you only track your car, this may be ideal. But for people like me who mostly drive it on the street, I would reccomend getting an air filter attached somehow to the intake side of the blower.
You sure that's for LS1's? I just found this post here and it's a LT1 using it. Looked like he cut it and then used dry hose.
http://www.supercharger.net/members/david/intake.htm
#34
Re: protoype 4" elbow
Looking back at it, I believe it actually is for an LS1. The inlet side of the Procharger blowers for the LS1 cars faces the front of the car (much more room), where as for the LT1's face the back of the car where you run into clearance issues with an aftermarket inlet tube. I am not saying it can't be done, but it will be difficult.
#39
Re: protoype 4" elbow
1 will be ready Mon or Tues to go out....the other 2 maybe the end of the week...i need more pipe there was a pipe that was over 4" in the bend like 4 1/4 and it makes a mess of the elbow
#43
Re: protoype 4" elbow
Originally Posted by ZBLKHELLRZR
Man somebody needs to build these things. Nice pics from both of you and I'm envious at the same time.
Thread
Thread Starter
Forum
Replies
Last Post
Pampered-Z
Suspension, Chassis, and Brakes
0
04-14-2015 05:38 PM