Drivers seat belt buckle continuity test for Air Bag Module
09-09-2013 | 11:46 AM
#1
Thread Starter
Registered User
Joined: May 2013
Posts: 114
From: Severn, Md.
Drivers seat belt buckle continuity test for Air Bag Module
Does anyone know what continuity measurement could be expected when measuring the two pins on the drivers seat belt buckle wires that goes up to the air bag module.
Measured mine, and it was all over the map. This could be causing my air light staying on after the self test.
Any help would be greatly appreciated.
Measured mine, and it was all over the map. This could be causing my air light staying on after the self test.
Any help would be greatly appreciated.
09-09-2013 | 02:06 PM
#2
Registered User
Joined: Nov 2007
Posts: 910
Re: Drivers seat belt buckle continuity test for Air Bag Module
Don't have a '96 book, on my '94 it's only a N/C switch to chassis ground. Pin B is grounded to chassis. pin A grounded with belt UN-buckled, pin A open with Belt buckeled.
Thread
Thread Starter
Forum
Replies
Last Post
squarehead
General 1967-2002 F-Body Tech
7
01-15-2015 07:02 PM
chevroletfreak
LT1 Based Engine Tech
202
07-04-2005 05:00 PM