I just got some pics of my setup with Pacesetters. I've got the full 3" setup and am at stock ride height. The first 4 pics are of the stock exhaust, and the last 3 are of the true duals. This should give you guys a good idea of how much clearance you lose with true duals.

http://i2.photobucket.com/albums/y6/...Picture145.jpg
http://i2.photobucket.com/albums/y6/...Picture146.jpg
http://i2.photobucket.com/albums/y6/...Picture147.jpg
http://i2.photobucket.com/albums/y6/...Picture148.jpg

TD pics: First link is of the mufflers.
http://i2.photobucket.com/albums/y6/...Picture169.jpg
http://i2.photobucket.com/albums/y6/...Picture170.jpg
http://i2.photobucket.com/albums/y6/...Picture171.jpg

Overall I'm impressed with how well mine tucked up. The front on the driver's side is a little low, but not enough to scrape. I didn't get any pics of the system before I put it on, but it comes fully welded, very high quality with clean welds and good clamps, and it slid right over the headers with no problems. I highly recommend Lane's setup. He custom builds his kits, so there's no adjusting or tweaking necessary. www.lanesperformance.com

Jason

 

all i see is a soda can....can't make out the exhaust tubes at all...

but hey...if you can get a can under it...that's pretty good.

 

Try adjusting the monitor. The exhaust is black but is pretty dirty. The pic of the can under the mufflers is a close up. The black you see right above the can is the muffler. They're clear on my computer at least...

Jason