LT1 Based Engine Tech 1993-1997 LT1/LT4 Engine Related

1994 Z28 cranks but will not start?

Thread Tools
 
Search this Thread
 
Old 12-01-2013 | 06:29 PM
  #1  
ShermanZ28's Avatar
Thread Starter
Registered User
 
Joined: Dec 2013
Posts: 2
1994 Z28 cranks but will not start?

Driving down the highway my Z28 experienced symptoms of running out of gas; which was possible (I am embarrassed to say). After filling with 6 gallons of gas it cranks but will not start. Any suggestions/thoughts/ideas would be greatly appreciated!

In trying to find the problem, I have replaced: Battery, Fuel Filter, Ignition Control Module. All fuses under the hood and on the side of the dash are good. I have spark to the plugs (capped plugs against the block shows great spark). The fuel pressure reads 41 psi (proper range 41-47 psi). Fuel pressure regulator vacuum hose clear of any fuel. Starting fluid into the throttle body and it still wont start.

Any ideas? Thank you!
Old 12-01-2013 | 07:04 PM
  #2  
parkers Z28's Avatar
Registered User
 
Joined: Apr 2012
Posts: 563
From: north Carolina
Re: 1994 Z28 cranks but will not start?

Scan for codes ... There is a sticky on here for 94/95free scan
I think ???? dtc16 code shut's down single to the injectors ??

Last edited by parkers Z28; 12-02-2013 at 04:33 PM.
Old 12-01-2013 | 08:57 PM
  #3  
ShermanZ28's Avatar
Thread Starter
Registered User
 
Joined: Dec 2013
Posts: 2
Re: 1994 Z28 cranks but will not start?

Originally Posted by ShermanZ28
Driving down the highway my Z28 experienced symptoms of running out of gas; which was possible (I am embarrassed to say). After filling with 6 gallons of gas it cranks but will not start. Any suggestions/thoughts/ideas would be greatly appreciated!

In trying to find the problem, I have replaced: Battery, Fuel Filter, Ignition Control Module. All fuses under the hood and on the side of the dash are good. I have spark to the plugs (capped plugs against the block shows great spark). The fuel pressure reads 41 psi (proper range 41-47 psi). Fuel pressure regulator vacuum hose clear of any fuel. Starting fluid into the throttle body and it still wont start.

Any ideas? Thank you!
Also....system scan shows everything a-ok no codes appearing...thank you...
Old 12-01-2013 | 10:10 PM
  #4  
timnfxr's Avatar
Registered User
 
Joined: May 2012
Posts: 214
From: Long Island, NY
Re: 1994 Z28 cranks but will not start?

Check the fuel injector fuses. On a 95 its F9 and F10 (u/h fuse block). I don't know if a 94 is the same fuse numbers.
Old 12-01-2013 | 10:46 PM
  #5  
Injuneer's Avatar
Administrator
 
Joined: Nov 1998
Posts: 70,841
From: Hell was full so they sent me to NJ
Re: 1994 Z28 cranks but will not start?

How did you scan it?
Old 12-02-2013 | 04:36 PM
  #6  
parkers Z28's Avatar
Registered User
 
Joined: Apr 2012
Posts: 563
From: north Carolina
Re: 1994 Z28 cranks but will not start?

Not all codes will show up on a scan tool .. what scan tool did you use ???
Old 12-02-2013 | 06:53 PM
  #7  
Injuneer's Avatar
Administrator
 
Joined: Nov 1998
Posts: 70,841
From: Hell was full so they sent me to NJ
Re: 1994 Z28 cranks but will not start?

The codes will all show up. You may be confusing this with the fact that some codes do not turn on the SES light.
Old 12-03-2013 | 04:16 PM
  #8  
parkers Z28's Avatar
Registered User
 
Joined: Apr 2012
Posts: 563
From: north Carolina
Re: 1994 Z28 cranks but will not start?

Thank you for clearing that up for me ...
Old 12-11-2014 | 08:45 AM
  #9  
SCNGENNFTHGEN's Avatar
Registered User
 
Joined: Jul 2002
Posts: 1,579
From: The Land of Pleasant Living
Re: 1994 Z28 cranks but will not start?

I am having the same problem right now. Basically I have gone through everything I can think of short of draining the gas, putting fresh hi octane gas in the tank. I had the mds opti on, replaced that with a known good one, new opti harness too. It's getting a big fat spark. Has msd 6al ignition box. New plugs, msd wires, injectors cleaned and or replaced by boost labs...thought maybe the pump, just put a walbro pump in tank last night....no luck??? Love my LT1s, but this thing has me stumped...checked also last night for ****s and giggles compression on #3, just picked one 150psi compression.....idk wtf, meanwhile my T56 car runs like a top!!
Old 02-10-2015 | 05:38 AM
  #10  
edward0118's Avatar
Registered User
 
Joined: Feb 2015
Posts: 1
Re: 1994 Z28 cranks but will not start?

mine did same thing upon ready post i went different direction i removed the exhaust and whala it started seem my cat had melted and pluged off now reunnin like a dream 350 bucks later
Old 02-11-2015 | 08:10 AM
  #11  
grabbem88's Avatar
Registered User
 
Joined: Feb 2011
Posts: 433
From: St.louis
Re: 1994 Z28 cranks but will not start?

Just because fuses look ok don't assume the connections are too..

The ignition fuse in the box (engine bay) one of my wires going to it and the connector pulled out enough to let my car start

Our cars are old and anything is possible from bad pigtails breaks in wires due to heat age and nature especially critters but always K.I.S.S the problems first then look for the technical stuff..
Old 02-15-2015 | 12:13 PM
  #12  
BPS's Avatar
BPS
Registered User
 
Joined: Apr 2000
Posts: 510
From: Victoria, BC, Canada
Re: 1994 Z28 cranks but will not start?

Could be the fuel pump - same thing happened to me years ago. Try hitting the gas tank with a broom handle - sounds dumb but has worked for me in the past. if it starts then it's the pump.
Old 02-15-2015 | 02:39 PM
  #13  
Injuneer's Avatar
Administrator
 
Joined: Nov 1998
Posts: 70,841
From: Hell was full so they sent me to NJ
Re: 1994 Z28 cranks but will not start?

Not sure how important it is... "SCNGENNFTHGEN" has not been back to the site since 12/14/14,
Old 03-10-2020 | 11:05 PM
  #14  
DaRealGubnar's Avatar
Registered User
 
Joined: Mar 2020
Posts: 3
Re: 1994 Z28 cranks but will not start?

Originally Posted by SCNGENNFTHGEN
I am having the same problem right now. Basically I have gone through everything I can think of short of draining the gas, putting fresh hi octane gas in the tank. I had the mds opti on, replaced that with a known good one, new opti harness too. It's getting a big fat spark. Has msd 6al ignition box. New plugs, msd wires, injectors cleaned and or replaced by boost labs...thought maybe the pump, just put a walbro pump in tank last night....no luck??? Love my LT1s, but this thing has me stumped...checked also last night for ****s and giggles compression on #3, just picked one 150psi compression.....idk wtf, meanwhile my T56 car runs like a top!!
Did you ever find out what the problem was? I have a 1994 Camaro Z28 LT1 and am having the same problems
Old 03-12-2020 | 09:05 PM
  #15  
LT5's Avatar
LT5
Registered User
 
Joined: Mar 2016
Posts: 212
From: Kentucky
Re: 1994 Z28 cranks but will not start?

Well i read most of this, i have personally replaces over 6 optisparks in my time, it sounds like this is the problem, you can get a great manufactured one from cardone that is new which is what im running for under 100 dollars at summit, solved all my problems.


Quick Reply: 1994 Z28 cranks but will not start?



All times are GMT -5. The time now is 05:39 AM.