Best bang for the buck mods
#18
I put a baby stall on my DD Z28. It helps alot. I went small so I wouldn't be driving around with it unlocked all the time. (I'm usually in the 2400-2500 range around town)
Next on the list is LT's, new catback, 1.6 rr's, and a tune.
Next on the list is LT's, new catback, 1.6 rr's, and a tune.
#19
Im a little hesistant about putting nitrous on my daily driver. I dont race it either, so it would really be kind of pointless.
Im keeping an eye out for a set of used ceramic coated headers, either shorts or mids. Does anyone know if the 93s require a certain type of headers, I know some things are slightly different on them than the 94-97s.
Like I said earlier the roads are just too bad around here to have LTs and and not get them all banged up.
Im keeping an eye out for a set of used ceramic coated headers, either shorts or mids. Does anyone know if the 93s require a certain type of headers, I know some things are slightly different on them than the 94-97s.
Like I said earlier the roads are just too bad around here to have LTs and and not get them all banged up.
#20
i have a set of shorties on ebay right now that end in 2h:30 min off a 94. i went up to longtubes, and i'm in illinois too lol, southside of chicago
http://cgi.ebay.com/ebaymotors/1994-...Q5fAccessories
http://cgi.ebay.com/ebaymotors/1994-...Q5fAccessories
Last edited by pattracing212; 04-21-2009 at 02:38 PM.
#21
Get stainless steel headers. They can still be ceramic coated if you like, but mild steel on a daily driver is a mistake whether it's coated or not.
Also, note that the more expensive headers (like Kooks) have equal-length primaries, which both sounds better and makes more power than cheap headers (like Pacesetters).
Also, note that the more expensive headers (like Kooks) have equal-length primaries, which both sounds better and makes more power than cheap headers (like Pacesetters).
#22
Where is the best place to get stainless headers? I tried to search for Kooks and nothing came up for my 95 LT1. Since I am going to replace my head gaskets soon I am planning on putting headers on it.
Would ideally like to get stainless equal length headers.
Would ideally like to get stainless equal length headers.
#27
Hey Cap, this is what I did with my 93Z...
Scroll down to my name...
https://www.camaroz28.com/forums/sho...98#post5831098
Scroll down to my name...
https://www.camaroz28.com/forums/sho...98#post5831098
#29
#30
look in the glove box there will be a white stick read the code if u have GU2=2.73 and GU5=3.23 also if you car doesn't have the first gear in the automatic shifter also means that you don't have the performance rear end which is 2.73.