Can I re-use barley run Intake Manifold Gaskets?
#1
Can I re-use barley run Intake Manifold Gaskets?
So I put on the intake manifold and ran the car for about 10 minutes until I realized that I didnt do a great job of RTVing the rear of the block. It started leaking oil. I am going to pull everything off.
I was wondering if I could re-use the new intake manifold gaskets that I only ran for about 10 minutes. I know it's better to get new ones everytime the manifold comes off. But these were barely used. Any suggestions?
I was wondering if I could re-use the new intake manifold gaskets that I only ran for about 10 minutes. I know it's better to get new ones everytime the manifold comes off. But these were barely used. Any suggestions?
Last edited by Fast96WS6; 06-26-2005 at 09:40 AM.
#2
Re: Can I re-use barley run Intake Manifold Gaskets?
I think you should do it, then let us know how it worked. That way, if I'm ever in that situation, I won't mess up my car, or waste my time.
#3
Re: Can I re-use barley run Intake Manifold Gaskets?
Originally Posted by TUNDRKYS
I think you should do it, then let us know how it worked. That way, if I'm ever in that situation, I won't mess up my car, or waste my time.
#6
Re: Can I re-use barley run Intake Manifold Gaskets?
Originally Posted by TUNDRKYS
I think you should do it, then let us know how it worked. That way, if I'm ever in that situation, I won't mess up my car, or waste my time.
Which translates to " go buy some new gaskets"
Thread
Thread Starter
Forum
Replies
Last Post
dbusch22
Forced Induction
6
10-31-2016 11:09 AM
ModdedNerd
General 1967-2002 F-Body Tech
2
12-14-2014 10:28 AM
chevroletfreak
LT1 Based Engine Tech
202
07-04-2005 05:00 PM