Speed Density

Just wondering how many LT1s are using PortPro heads?

Any Dyno, ET results?

What are you flowing?

Tony.

Casey_SS

Interesting you should ask....I was just up there today talking to Harold about different options for my motor and checking out his progress on a friend's 440 Mopar that's about to go into a '70 Cuda.
He had a set of LT1 heads sitting on the bench that flowed around 285 if I recall. I know he's gotten more out of them but I believe certain castings are much better than others for porting. Don't know which this was vs. some his others.
As far as dyno goes, I know he's produced several that were in the 400 - 450 rwhp range with stock / ported intakes and a few solid cam, single-plane motors that put down ridiculous numbers, but I don't know the owners or exact specs.
No doubt about it, Port Pros builds some fantastic motors and as soon as my stock starts doing a little better, I'll have one myself. Don't know if I'll post results though....I think Port Pros is one of the best kept secrets around and I'd personally like to keep it that way
BTW, are you Tony Shepherd? If so, I've seen some of your stuff up there and have been following your progress since the write up in GMHTP and the video on Harold's site.....very, very nice

Sparkz28ss

Hey ...did you happen to see a clean back 92 z28 up at port pros?

Casey_SS

Actually, I did.....it looked awesome, although I didn't get to see the interior or under the hood or anything. Just kinda walked around it and asked some general questions in the midst of a completely different conversation. Looked like a really fun car though.....is it yours?

Honda Hunter

I believe Ive seen a post or two about them. Never heard a bad thing about them.

Sparkz28ss

nah...its my house mates....im not to into the 3rd gens but I love that one.
I was asking because he has not said much about it...he is working on a 97 SS that we just picked up from JeffK

it was a AFR headed forged 406 with 13.5cr .788/.798 lift , victor SR ..all kinds of stuff ....almost made 800hp at he flywheel....ALMOST..heh..thats why its there...new pistons and bearings,to much CR for the street..I think he only went 5 miles on the engine...

that car is nasty....you should check out the inside ..its really clean and well done

LameRandomName

U.D. Harold?

firetird

Tony aka Fast93z has most of his work done through Port Pros. I had him do my throttle body and it turned out nice but the customer service was poor to say the least. All in all he does really good work and not too expensive either.

fast 93 z

Hey guys!!

Yea Port Pros definately is on top right now and finally people are noticing. As far as customer service he is awesome! Always returns emails and phone calls and has great tech info. Harold bends over backwards to help people out and goes above and beyond for his customers. And his employees are the same.

Casey SS...........thanks for following the progress on the car. It will hopefully now belong to the elite 8 second club.

Tony Shepherd

Speed Density

God damnit Shepard, he thought I was you. That woulda been sweet until he asked for specs about the 9 second 93', then i would have been screwed.

Well at this point ive changed my motor setup from a Forged 355 to a 396ci and im thinkin the heads are going to be AFR 195cc or hand port my LT1 castings in town to save a little cash since i have college coming up.

fast 93 z

LOL

Definately get some good flowing heads for a 396. Oh......and college comes first cars second!!!!!