Magnaflow owners inside please
#1
Magnaflow owners inside please
I had an exhaust shop install the Magnaflow on my car, just because I needed a cat welded in at the same time. Yesterday, I tried to pull the driveshaft out (LS1 3") and it wouldn't come out because of the I-pipe. Does anyone else have the same problem?
I had loosen up the clamps and it was still hard to take it out.
The exhaust itself seems to be installed right and from looking at it, I don't see how it would be possible to move the I-pipe unless heating it up and bending it some....
I had loosen up the clamps and it was still hard to take it out.
The exhaust itself seems to be installed right and from looking at it, I don't see how it would be possible to move the I-pipe unless heating it up and bending it some....
Thread
Thread Starter
Forum
Replies
Last Post
ducttape1975
New Member Introduction
2
07-10-2015 06:29 PM