New Intake Elbow...Pictures & Problems
#31
Try one of these. https://shell7.tdl.com/~jags/Pages/P...n_Ducting.html
have you purchased one of these elbows? which one did you use?
#32
Registered User
Join Date: Aug 2003
Location: brunswick ohio, small burb south of cleveland
Posts: 420
i have c5 z06 rims. they fit a 275 40 17 to that rim. here is the link to the available sizes from MT.
http://www.mickeythompsontires.com/s...ETStreetRadial
i also used a 12" TC so i wouldn't have to upsize a trans cooler. that limited my stall to about 2400 because i didn't go smaller in size. next time i would go with a smaller TC with a higher stall speed. probably at least 3400.
david
http://www.mickeythompsontires.com/s...ETStreetRadial
i also used a 12" TC so i wouldn't have to upsize a trans cooler. that limited my stall to about 2400 because i didn't go smaller in size. next time i would go with a smaller TC with a higher stall speed. probably at least 3400.
david
#36
I don't remeber how long the stock elbow is because I never had one on my car. But I don't think it will be long enough. I just measured mine and it's about 1 1/4" from the inside bend to the end of the rubber. The end of my mas air looks like it's right in line with the edge of the throttle body. Hard to explain, but I hope that helps.
Thread
Thread Starter
Forum
Replies
Last Post
slothgrant
Car Audio and Electronics
0
08-22-2002 03:01 PM