sean1997ws6

Added the summit racing 3 inch cutout($26) to my car and got 2 tenths consistantly from it, I was very pleased to get 2 tenths for a grand total of $66 bucks(40 to install). GREAT BANG FOR YOUR BUCK!

Deadcarny

more people need to see this! I did not have track times when I did mine, but I picked up a little over 8HP and 9FT-LBS at the wheels on a bolt on car by opening mine. Since then, I have raved about the bang for your buck of a cutout, and people try to deny it because of the whole 'Backpressure' myth!

1994CamaroZ28

I have not denied the bang for the buck of a cutout first time i was at the track i ran a 14.24 best of the night went back with a cutout 13.9 i got the slips somewhere

reuter

did yall have LTs when you had the increase in power or was it on stock manifolds?

sean1997ws6

I dont have LTs , I have the edelbrock shorties. I recomend this cutout to anyone, its awesome.

jd94z28

Where along the exhaust path did you place the cutout?

1994CamaroZ28

http://hav0k.hypermart.net/cutout.jpg

sean1997ws6

After the cat under the pass. seat, the fbodys have a little place in the under side where is looks like it was almost put there for the cutout. Its about 8inches before the pipe jumps over the rear.

FacelessZ

I have mine immediately after my cat...I was told that there wasn't any room before the cat until I went with LT's...

NoFear95

Put mine right in the cat-pipe. Very nice installation from Finish Line Performance!!!