No Idle, Runs ROUGH & smoke...
#1
No Idle, Runs ROUGH & smoke...
Hey everyone,
Good news = I got my LT1/3rd gen fired up this morning.
Bad news = Its not running well
-It wont idle. While starting, the engine will catch for a split second, but then dies
-If I hold the gas on a little, it will run but extremely rough & smoke comes out the exhaust. And the exhaust smells like fuel.
I am guessing its an ignition problem, but I dont know where to start. Here are some details...
96 LT1
PCMforLess tune
New GM opti w/ MSD cap & rotor
45-50psi of fuel
I dont have a history with the Coil & Coil control module
Any suggestions?
Good news = I got my LT1/3rd gen fired up this morning.
Bad news = Its not running well
-It wont idle. While starting, the engine will catch for a split second, but then dies
-If I hold the gas on a little, it will run but extremely rough & smoke comes out the exhaust. And the exhaust smells like fuel.
I am guessing its an ignition problem, but I dont know where to start. Here are some details...
96 LT1
PCMforLess tune
New GM opti w/ MSD cap & rotor
45-50psi of fuel
I dont have a history with the Coil & Coil control module
Any suggestions?
#2
OK I got it. Ended up being a combonation of two things...
MAF & MAP
One of the things I had tried earlier was disconnecting the MAF to rule it out. Then car wouldnt even start with the MAF unplugged. So I replaced the MAP sensor and then tried disconnecting the MAF again... Whala!! The car is running on Speed Density right now... BUT IT RUNS!!! Im am so pumped. I cant wait to get the accessories hooked up & get a new MAF so I can take it out for a spin!!
P.S. Open headers are great!
MAF & MAP
One of the things I had tried earlier was disconnecting the MAF to rule it out. Then car wouldnt even start with the MAF unplugged. So I replaced the MAP sensor and then tried disconnecting the MAF again... Whala!! The car is running on Speed Density right now... BUT IT RUNS!!! Im am so pumped. I cant wait to get the accessories hooked up & get a new MAF so I can take it out for a spin!!
P.S. Open headers are great!
Thread
Thread Starter
Forum
Replies
Last Post
F(ast)-body
LT1 Based Engine Tech
8
02-26-2003 09:05 AM