To port manifold or to not port?
#17
Hmmm. I see what happened, then. I have holes, too, but my gaskets didn't have any pins to go into them. I used Felpro FPP-1284 from Summit, which they list tor the LT1. Maybe not the best choice...? You can see they have holes instead of pins, and I assume that means they are set up to have pins in the heads.
Not trying to hijack, but knowing about this will help the OP and me both.
Not trying to hijack, but knowing about this will help the OP and me both.
Last edited by JP95ZM6; 12-26-2007 at 10:26 AM.
#18
Hmmm. I see what happened, then. I have holes, too, but my gaskets didn't have any pins to go into them. I used Felpro FPP-1284 from Summit, which they list tor the LT1. Maybe not the best choice...? You can see they have holes instead of pins, and I assume that means they are set up to have pins in the heads.
Not trying to hijack, but knowing about this will help the OP and me both.
Not trying to hijack, but knowing about this will help the OP and me both.
Thread
Thread Starter
Forum
Replies
Last Post