which vavles to use
#1
which vavles to use
I am going to be getting a set of heads done and i getting 2.00/1.56 valves put in, but i am not sure what brand.. I am thinking manley, but then i don't know wich valve is better from them.. Any insite would be nice.. Which manley, or is there a better valve company out there for a decent price?
#3
I have a full set of Ferrera Severe Duty 2.00/1.56 valves. They are already backcut and have a multi-angle competition valve job. They are stock length. I tried to sell them in the Parts for Sale forum, but nobody seemed interested. I have them on eBay right now, but there have been no bids, so I can cancel the auction if you are interested. There is absolutely nothing wrong with these valves they were installed on a set of heads, but the heads were never installed on the engine. They are basically brand new. E-mail me if you are interested. sseeya@earthlink.net
Last edited by sseeya; 02-27-2003 at 04:50 PM.
#4
If whomever is doing your heads is competent, they should be telling you what to buy, or buying it for you.
FWIW, IMO ferrea's valves are nicer, but they're more expensive.. figure $225 or so for a set of ferreas and $175 or so for manley race-flo valves.
There's benefits to either valve, but either will work fine.
FWIW, IMO ferrea's valves are nicer, but they're more expensive.. figure $225 or so for a set of ferreas and $175 or so for manley race-flo valves.
There's benefits to either valve, but either will work fine.
Thread
Thread Starter
Forum
Replies
Last Post
firehawkclone
LT1 Based Engine Tech
1
01-18-2004 08:13 AM