Hey Guys about to be buying a house, My loss is your Gain, this is a WELL built solid roller LT1, that was going in my 94 camaro that I have been building for about 2 years.... Motor was just wrapped up and finished about 2/3 months ago, it has been ran on engine stand for break in for about 30 minutes to an hour by the engine builder.... Motor is built for spray, I was going to spray about 300-400 on it through 2 kits. Here is details on the motor

Before the motor went to Machine shop I had already purchased and supplied
Scat 4340 Crank
Scat 5.700" H-Beam Rods
Dart single Plane intake
CSR Electric Water Pump
Performance Products Balancer
LT4 Heads *LE3 ported* Re worked by Machinist
(thats all that comes to head)

ATTACHED BELOW IS THE TWO FINAL BILLS ON PARTS AND LABOR SO YOU CAN SEE IN DETAIL WHAT ALL IS DONE AND WHAT IT COST

Not included on the Final Bill but was done at time of building engine is...
Straight bolt caps, three center caps are billet 4 bolt and the front cap is billet 2 bolt...

Your more than welcome to contact my Machinist about the build as I put a lot of money in it! As I started the build and it went on we built it as much as we could while my goals were to see the car go low low 6's maybe touch a 5 in the 1/8th mile in a almost full weight convertible

I also have a Rossler Manual Valve Body turbo 350 with Rossler T-Brake and Trans Specialties 4600 converter, shifter and all included if someone would be interested in a package deal, I have ran the Transmission prior to this motor about 3 passes in another car and IT IS BULLET PROOF

Below is a video of a Camaro With the Exact same build setup as what I have built here!!!

movie2.mp4 video by kkline454 - Photobucket


FEEL FREE TO ASK ANY QUESTIONS OR CALL OR TEXT ME 270-331-2357

Check my feedback im a very honest seller!

 

Closing on a house, need to move it $3500.00