Borla muffler...
07-17-2007 | 08:34 PM
#1
Thread Starter
Registered User
Joined: May 2003
Posts: 139
From: WI.
Borla muffler...
Sku# on jegs~157-40085 link~ http://www.jegs.com/webapp/wcs/store...10002_15934_-1
*Note* on pic one that there is a little bend in the mesh on one end. That can be straightned out and it will not interfear with the performance of the muffler.
Asking $50 obo, buyer pays shipping if shipping is needed. PM me if intrested, thanks Nick S.
PS it was orignally on my 2000 TA for a very short amount of time, barley used.
*Note* on pic one that there is a little bend in the mesh on one end. That can be straightned out and it will not interfear with the performance of the muffler.
Asking $50 obo, buyer pays shipping if shipping is needed. PM me if intrested, thanks Nick S.
PS it was orignally on my 2000 TA for a very short amount of time, barley used.
07-20-2007 | 02:41 PM
#5
Registered User
Joined: Jul 2003
Posts: 43
From: oklahoma
I have a magnaflow cat-back 3" exhaust will this bullet muffler fit if I cut it into the straight pipe right after the cat.? Jegs info says in 5in in diameter but don't know if i will have clearance issues with this hitting the floorboard.
Where did you have this installed at in you exhaust system?
Where did you have this installed at in you exhaust system?
Thread
Thread Starter
Forum
Replies
Last Post