Comp Magnum pushrods (Stock LT1 length)
08-22-2007 | 06:44 AM
#1
Thread Starter
Registered User
Joined: Oct 2003
Posts: 1,454
From: MN/WI
Comp Magnum pushrods (Stock LT1 length)
Comp magnum 3/8” x 7.200” pushrods
ISKY adjustable guideplates (for 3/8” pushrods)
Less than 20 miles on both
Price drop --> $140 Shipped in the lower 48.
I just paid $188 new about 2 months ago.
I used these with an LT1 hydraulic roller setup and they worked flawlessly. The larger diameter (vs. 5/16" stock) is more rigid but doesn't need extra clearancing and didn't have any detrimental effect on my valvetrain at 7000rpm with .600+ lift (no valve float etc).
They were only pulled since I am parting out my car to move onto something else.
ISKY adjustable guideplates (for 3/8” pushrods)
Less than 20 miles on both
Price drop --> $140 Shipped in the lower 48.
I just paid $188 new about 2 months ago.
I used these with an LT1 hydraulic roller setup and they worked flawlessly. The larger diameter (vs. 5/16" stock) is more rigid but doesn't need extra clearancing and didn't have any detrimental effect on my valvetrain at 7000rpm with .600+ lift (no valve float etc).
They were only pulled since I am parting out my car to move onto something else.
Last edited by TQdrivenws6; 09-07-2007 at 08:19 AM.
08-27-2007 | 01:37 PM
#8
Thread Starter
Registered User
Joined: Oct 2003
Posts: 1,454
From: MN/WI
Stock length, but 3/8" OD compared to stock 5/16"OD. The rigidity is significantly increased with the larger diameter. I used them with non-self aligning Comp Pro-Mags so I picked up a set of the ISKY adjustable guideplates for 3/8" pushrods.