Up for sale is an Forged 383 LT1 Bottom End Complete:
Block bored 4.030, Forged Scat Crankshaft, H Beam Scat Rods, Forged Speed Pro Pistons, made 11.2:1 Comp Ratio, I dyno'd 416RWP with this setup 2 years ago with a very mild heads cam setup. This setup can handle much, much more. Everything is balanced and the bottom end is ready to build. This bottom end has about 1500 miles on it, THATS IT!! This would be perfect for someone getting ready to build a 383 LT1! $2000 or best offer, I will entertain reasonable offers.

I have a nitrous works dry kit for LT1's, 75HP-175HP Jets, comes with plate, 10lb bottle, nitrous line, and solenoids. This kit has only been used a handful of times and it is still in very good condition (kit comes minus the fuel line) $300

I have a like new set of Comp Cams Pro Magnum Roller Rocker Arms for sale, they are 1.6 ratio and 3/8 stud, they have about 1500 miles on them as well.
$200 or best offer, I will entertain reasonable offers

 

Where you located?

 

Winchester, VA

 

what's wrong with the bottom end?

 

Is the block splayed or 4 bolt? Would you sell just the rotating assy?

 

There is nothing wrong with the bottom end, I am parting out the car and the bottom end happens to be on an engine stand in my garage so I need to sell it.

The block is not splayed but I do have 4 bolt main caps for it, I do not want to dissassemble the bottom end, so you can buy the rotating assy. and I will throw in the block for free.

-Mike

 

any offers?

 

pm'ed ya