Tried to trade these for the muffler I wanted but nobody's up for it, so I was thinking I'd just sell them off. Asking for $65+ shipping for the muffler, side pipes, and tips all as one piece (welded to line up correctly with provisions for hangers. Aka the entire rear section. List price for the muffler itself is $80 and the tips are around $50 so its a good deal. No rust, no damage.

 

3" in, dual 2.5" out I'm assuming, can it be easily mated up to the stock I-pipe on a Z28 you think? Know if there are any major differences in the mounting/hanging of the exhaust between the V6 and V8, kinda new to fourthgens...

I'm over near Stone Mountain, may be interested if it will work on my 94 Z28 without much trouble...

 

Yes, it is 3" in / dual 2.5" out. This is coming off of Hooker's 3" catback system for the 93-95 lt1 camaro/firebird actually. I got the system for my v6 b/c it comes with the integrated "s" bend at the end of the i-pipe. But as stated, this is for the muffler, the pipes coming out of it, and the tips, all of which are one piece. The muffler inlet was not cut, it comes with a flange to bolt to the overaxle pipe in the kit so any muffler shop could cut off the flange and reduce the pipe diameter a tiny bit to slip over your 2.75" factory z28 pipe (aka, it would work just fine both fitment and hangar wise) Let me know if you would like it.

Here's the kit it came from so you can see exactly what the muffler/pipes/tips look like (except the i-Pipe with the s-bend which im not selling):

http://fasttoys.net/shop/product_inf...roducts_id=187