First, I must apologize to everyone who may have tried to previously contact me for parts from my car and not gotten a response. My computer recently crashed (and still isn't up yet) so I haven't been able to check much.

Here's a few things I have.

-stock 10 bolt, 3.23's, LSD, disc brakes on it (I can take them off if you don't want the brakes), 3 channel ABS - $250 w/ brakes, $200 w/out
-front disc brakes (calipers/rotors/slightly worn pads) - $50
-stock springs - $30
-stock LT1 driveshaf - $40
-A/C pump - $50
-Power Steering pump - $50
-Water pump - $75
-Opti spark - $50
-ABS unit - $75
-Cruise control unit - $50
-AIR pump - $30
-'95 PCM w/ wiring harness and LT4KM
-Taylor 8mm wires, blue (brand new never used) - $30
-CC306 cam w/ 111ls (has a broken dowl pin that needs to be drilled/replaced, I'll include the dowl pin though, you just hafta get it replaced) - $120
-EVERY LT1 engine part except the block (pistons, rods, crank, heads, intake, lifters, cam, etc) - $make offer on part
-convertible top pump - $50

I have a 4L60E transmission as well, but the housing is cracked up a bit. If you need any particular transmission parts though, I can take those out of the tranny and sell them as well.

To those who contacted me about the headers that I couldn't reply to, once I got the passenger side headers out, they're simply too bent to sell. Two of the pipes got completely crushed.

If you need anything, once again, please don't email, PM me, or post a reply to this thread!!! as I can't check those often w/ my computer being down. Either call my cell phone @ 281-923-2507, or you can send me an IM on AIM @ GrdLock31337. (I have AIM set to forward my IM's to my cell as well)

 

I will give you 135.00 shipped for the 95 OBD1 computer and the harness

 

Dude your lucky to be still with us, holly crap!!

 

"Holy cr@p is right!" I say as I wipe the tears from my cheeks. She was so sweet looking. What a shame. What kind of damage did you sustain?

 

How much for the PCM/Harness?

 

Well, threadedtire already offered $135 in a post above, and I sent him an email. If he ends up changing his mind or something I'll let ya know.

And yeah, I know the wrecked sucked ***, luckily I didn't even get hurt though. Well, I got a concussion and a few scrapes, but looking at the car I'm lucky that's all I got! Such a shame, I loved that car too!

 

How much is shiping on the rear end?? toSouth FL.. what do you think?

 

$50 shipped for the opti if 94 or 93 non vented. Will call after work. Thanks Dana

called: 95 vents opti (Of course )

 

The opti is a '95 vented, but if you still need wires or lifters let me know.

 

It would hafta be shipped freight, my guess is around $85. I ordered a Moser rear-end a while back, and freight shipping on it was $95, and it's a little heavier then a 10 bolt.

 

about how many miles on that opti? Was it the stock one?

 

Hey, brook, do you still have the PCM you were gonna sell me? Looks like I need it now. Later

 

if you still go the wires, ill pick them up when i come get the headers. unless there already sold.

 

Not sure how many miles on it. I know it's not the original, and that the previous owner of the car replaced it at least once, but he never told me the particular mileage that he replaced it at. All the parts I'll be selling are currently in perfect working condition. Of course I can't guarantee anything, as a lot of the stuff was on the car when I got it, but I can guarantee that it's all in working condition as of now.

 

Hey! This is MY for sale thread! Get your own! Damn thread stealer.