LS1 short block, heads, cam, stall, tranny, etc for sale!
03-04-2007 | 12:55 AM
#1
Thread Starter
Registered User
Joined: Feb 2002
Posts: 117
From: Cypress, TX USA
LS1 short block, heads, cam, stall, tranny, etc for sale!
Selling the following from a 1998 WS6 with only 38k Miles. I am willing to deal so obo!!
Short block - ($750) I installed my new PRC heads & 230/234 Cam and while on the dyno it went POP! Spun a rod bearing. It was NEVER driven after this happened. It was shut down 3 seconds after, rolled onto the trailer and dropped off at the shop again.
TR224 cam - ($300) 224/224 563/563 lift. Cam not run much at all, and was not in the engine above when rod bearing was spun. Great little cam that can make 400rwhp with right setup.
Heads - ($400) these are ls1 heads that have titanium retainers and 918 springs. Not run for very long either, and work great! These were not on the motor when the spun bearing happened either.
4l60E Transmission - ($600) low miles, no real power has gone through it, not abused and in great working order.
TCI SSF 3500 Stall - ($300) low miles, same as above - no real power has gone through it, not abused and in great working order!
valve covers - ($25)
exhaust manifolds - ($40)
ls1 intake - ($50)
MAC Off Road Y Pipe - ($100) - these mated up to my exhaust manifolds
Short block - ($750) I installed my new PRC heads & 230/234 Cam and while on the dyno it went POP! Spun a rod bearing. It was NEVER driven after this happened. It was shut down 3 seconds after, rolled onto the trailer and dropped off at the shop again.
TR224 cam - ($300) 224/224 563/563 lift. Cam not run much at all, and was not in the engine above when rod bearing was spun. Great little cam that can make 400rwhp with right setup.
Heads - ($400) these are ls1 heads that have titanium retainers and 918 springs. Not run for very long either, and work great! These were not on the motor when the spun bearing happened either.
4l60E Transmission - ($600) low miles, no real power has gone through it, not abused and in great working order.
TCI SSF 3500 Stall - ($300) low miles, same as above - no real power has gone through it, not abused and in great working order!
valve covers - ($25)
exhaust manifolds - ($40)
ls1 intake - ($50)
MAC Off Road Y Pipe - ($100) - these mated up to my exhaust manifolds
03-04-2007 | 01:15 AM
#2
Registered User
Joined: Nov 2004
Posts: 2,475
From: Garland, tx
Thread
Thread Starter
Forum
Replies
Last Post
F(ast)-body
LT1 Based Engine Tech
8
02-26-2003 09:05 AM