Just trying to clean out the garage a little bit to free up some extra cash for the 383 that I have planned...the stuff below is what I have listed for sale. All mileages are estimates within 1,000 miles. If you are paying with paypal, add a 3% fee that they charge me.

Stock LT1 camshaft: $15 + shipping (the middle and rear journals have scores on them from rolling on the floor once...I will clean this up with some emery cloth before it gets shipped the best I can - no guarantees, but if anybody needs it)

Set of 16 stock pushrods (non-hardened): $15 + shipping

Set of 16 rocker arms (with nuts/ball pivots): $25 + shipping

Set of 16 valve springs (with retainers/seats/keepers): $30 + shipping

Stock timing chain/gears: $15 + shipping

OR buy the whole valvetrain for $75 + shipping

All valvetrain has 69,000 miles on it and were in good condition when taken off the car. Valvetrain was taken off to swap in the LT4 hotcam kit.

Stock torque arm (75,000 miles): $20 + shipping
Stock tin crossmember (75,000 miles): $5 + shipping
Stock front swaybar (65,000 miles): $25 + shipping
Stock rear swaybar (65,000 miles): $20 + shipping
Stock lower control arms (62,000 miles): $20 + shipping
Stock panhard rod (62,000 miles): $10 + shipping
Stock exhaust manifolds (65,000 miles): $35 + shipping
Stock dual catalytic convertors (65,000 miles): $50 + shipping (expensive shipping)
Stock air inlet duct with tube that attaches downward (65,000 miles): $15 + shipping
Set of 20 wheel lug nuts (Never used): $15 + shipping

Stock washer fluid reservoir w/ washer pump (69,000 miles): $15 + shipping
Stock EGR valve w/ solenoid (2,000 miles - just put on, then I took it off to convert to non-emissions): $20 + shipping SOLD
Stock EGR pipe: $5 + shipping SOLD
Stock AIR pump w/ solenoid/ vacuum hoses (2,000 miles - just put on, took off to convert to non-emissions): $25 + shipping SOLD
Stock front O2 sensor (69,000 miles): $15 + shipping
Stock rear O2 sensor (69,000 miles): $15 + shipping
LT1 (not LT4) knock module (69,000 miles): $5 + shipping

O2 sensor simulator (1,000 miles - got PCM programmed, don't need this. I only have one, the other one got burned): $25 + shipping - SOLD

Anything else you are looking for I could possibly have laying around, just let me know and I will give a look for it.

 

ttt

 

ttt

 

ttt

 

I'm intrested in O2sim.
Can you do 25shipped?

 

Yeah, 25 shipped sounds just fine to me. Just e-mail me with your address and info and we will work something out.

Thanks

 

EDIT - Sold the O2 simulator...ttt

 

TTT

 

ttt

 

ttt

 

are the sway bars still for sale? do they have all the parts needed to install(bushings, ect.)?

 

yes, I still have the sway bars for sale...unfortunately I dont have the bushings. I have some of them that I could look for but Im not positively sure that I have all of them.

Let me know.

 

The lug nuts and the emissions (EGR) stuff have been asked about. ttt

 

i need the crossmember, and passenger side lower control arm, and maybe the front sway bar if its still available. what year car was this off of? is it the motor crossmember for an LT1 hardtop, or is it the transmission crossmember? i might have read your post too quick, i need the motor crossmember, and the front lower control arm, are you selling the rears or the fronts?.

strangeitalian@hotmail.com

thanks a lot

 

The crossmember that I have would be the stamped steel crossmember that is directly below the transmission that has 4 bolts to hold it in place.

The control arms that I have would be the rear lower control arms. I dont have any front control arms available.

I do still have the front sway bar available if you need that.

All parts are coming off of a 1997 Z28 Camaro.

Just let me know.