Sorry for the huge post but I just copied my craigs list ad down on here. Dont try selling anything on craigs list, all you get is spam from people who wanna send ya millions of dollars if only you will give them your account numbers
==Sorry but no shipping on this stuff. Ive almost never had goodluck shipping any parts so i will keep this kinda local if possible. Can meet around Marietta Ohio, Parkersburg WV, or some areas close by, let me know.==
NO Warranties expressed or implied, everything as-is, iam being as honest as I can here on the condition of this stuff and can bring it for you to see if your close before you buy. I have a digital camera and can try to get pics on here if interested. Would probably be easier to email them, so either reply or PM and email address.

4l60e transmission out of 94 Z28 Camaro.
Had the pump and seals etc etc replaced maybe 20k miles ago? Dunno if the whole trans has ever been rebuilt or not, but it has a GM Reman converter with it. I would suggest using a new converter though since mine has been sitting for a few years(as has the tranny). Will need new Pan, somebody drilled a hole in this one to drain the fluid...
Swapped to a t56 in my 94 Z, changed gears and never had shift points/speedo re calibrated so I got used that as an excuse to go 6speed.
Comes with a 'corvette' servo, new in box. Supposed to be better than a camaro servo?? I dunno much about autos if you all cant tell yet.
Please note this is a commputer controlled tranny, no kickdown cable.
Fits all SBC/Lt1 and possibly 4.3 v6's.
Total miles are roughly 105k.
Asking $300 obo/

RAM Billet Aluminum flywheel for LT1, possibly all SBC. 153tooth if i remember correctly, 18lbs.
Has weights in it, for an external balance setup or stock lt1 setup (which is external balance at rear).
Only has maybe 300 easy miles on it. Had a slight vibration(go figure right?)=Needed a 0-balance flywheel, didnt pay attention and had a buddy install it only to find out later on it was the wrong flywheel. My mistake.
Very expensive new, sell for $275 obo.

Nitrous Express Wet Kit with big bottle (dunno what size) already full.
Supposed to be for any fuel injected engine. Cost like $5xx On ebay now??
Nitrous Purge Kit, and Bottle Warmer.
Only used twice for dyno tuning old engine, works perfectly. Has everything except 2 toggle switches and 1 button that is staying in the car.
Might need some misc wiring to the switches, not sure if it was removed from my car or not.
Also comes with switch to activate on WOT, physical type switch that rubs the throttle body linkage.
Will need to pull main Nitrous feed line and Bottle Brackets out of my car if interested but can be done ASAP.
Almost complete! (switches, maybe wires)
Parts are all in a zip-loc bag and available to be looked at.
Don't have any instructions or paper work on it, got it from a friend who installed it on his car but never used it and simply removed and sold it to me.
Jet sizes are I think 50/100/150 if i remember right. Its been a while since i had it on the car.
All these parts seperately cost big bucks, sell for $320 EVERYTHING.

Possible Trades Accepted:

=Ford 9-inch rear axle housing and any parts to go with it like axles, gears, =third members, brackets, brakes. that will fit a 4th gen F-body Camaro or =Firebird 1993-2002 years.
=Tandem Axle Open Car Trailer, Prefer NOT home made.
=Yamaha sport bike, not too picky on years or miles.
=I know unless someone wants EVERYTHING iam not gonna be able to trade straight up for any of this stuff but let me know what ya got even if i didnt list it.