Heres the story, I have a nissan 300zx tt I just sank 10000$ into. Over the weekend I let my freind drive the car and he hit a parked car and totalled it, NO COLLISION insurance. I just put a new motor and trans in the car, which I would like to now put in a 98 and up camaro or trans am roller, but Im low on cash. So heres what I have to trade or sell.


400cu 2 bolt block with splayed studded mains and billet main caps.
lifter bores have been bored for bigger lifters, every trick in the book has been done to the block.
350cu cola crank in the motor that was around 4000 new,knife edges and camferd.
manley rods, not the tour light...the 1800$ ones. forget the name off hand
JE pistons, 1100 for 10 of them, can handle a 500shot 12:1 comp
All pro spread port 20 degree cheater heads. 2.125 TITANIUM intake valves 1.6 exhaust, coolant lines from front to back
brodix port matched intake
jessel shaft mount rockers.
Alum valve covers with oilers built in
700 inch lift cam, made for drag.
4 stage dry sump
msd crank trigger
msd billet distributer
10mm wires
electric waterpump

This is just a ruff description, I have all machine work reciets. motor cost 15000-16000$ to build. 7600 of it machine work. Should put out 750hp all motor, 1000 on spray. Could go more but the block may be the weak link.

Im willing to sell it for 7500 obo or trade for a 98 and up camaro or trans am roller/ or hole. Prefer a 5 or 6 speed car, dont care if its a v8 car. Just clean body. Depending on the roller I may want some money also.