Hi all,

I have a problem, any help greatly appreciated. I've got 95Z that I just recently had the tranny rebuilt in. Tranny runs great, but the problem is when I stomp it and I mean to the floor, it shoots straight to about 6000 to 6200 rpm. I'm not sure where the rev limiter is typically set, I would think lower, but at any rate needle shoots straight up. Once the limiter hits the car jerks until I lightly let off the gas and then it shifts. It's starting to be a pain in the you know what. I originally thought it was the TPS, but I'm not sure. I had the MAF descreened, which I have since put back in and it seemed to help. I am not sure what the problem is I just know it's still bad. If I accelerate with the pedal little more 3/4 to the floor the car shifts perfect at around 5200-5400. Again, any help appreciated.

Anybody local that might have a scanner for OBD I? Or, any other ideas on how to diagnose this? Thanks!

Ken

 

try asking in the LT1tech section, youll get more answers.

 

Sounds like a bad rebuild to me... take it back.