Rear brake hose fitting
#1
Rear brake hose fitting
I'm using some '95 Camaro rear calipers, and I'm trying to makes some braided hose for the rear. I can't figure out what banjo bolt to use.
My local speed shop has 10mmx1.25, which looks like the same thread size. But when trying to bold it in, it went in a little ways, then snugged up. And the threads looks shiney, like the bolt was removing material. The calipers I'm using are new rebuilt units, so maybe the threads are a little rough.
Anyone know what thread size I should be using?
My local speed shop has 10mmx1.25, which looks like the same thread size. But when trying to bold it in, it went in a little ways, then snugged up. And the threads looks shiney, like the bolt was removing material. The calipers I'm using are new rebuilt units, so maybe the threads are a little rough.
Anyone know what thread size I should be using?
Thread
Thread Starter
Forum
Replies
Last Post
PFYC
Supporting Vendor Group Purchases and Sales
0
12-04-2014 11:56 AM
bossco
Automotive News / Industry / Future Vehicle Discussion
4
11-29-2014 10:18 AM
chevroletfreak
LT1 Based Engine Tech
202
07-04-2005 05:00 PM