ride height problem
#31
still stock controll arms. and rubber bushings. i am going to wait until i do the k-member to change all of that stuff.
anyway, i thank you. i will give this a try. ill repost in a few days after i get it all apart.
anyway, i thank you. i will give this a try. ill repost in a few days after i get it all apart.
#38
i had the same issue on the left front after a complete suspension overhaul...left frt upper strut mount were the culprit.....but my 94 had a hard 95k on it. replaced them and ride height is level again. in your case this might not be the issue because i'm asuming your 2002 dosen't have almost 100k on it. just my .02
#39
no, 40k. but im gonna check evertyhing again when i re-aligh the controll arms. but are you talking about the rubber part taht sits at the top of the spring?
Last edited by SpeedDemon02SS; 01-15-2007 at 10:39 AM.
#40
yes the rubber mount at that holds the spring/shock (strut) together at the top. if you can take the strut out, (driver side is more complicated because of master cylinder) look in the area were the shock proturdes through the rubber mont with the nut holding the shock and rubber mount inplace. if it torn or in bad shape that is most likely the culprit. with only 40k on the car, it sems unlikely the strut mount is the problem.
#41
yea, those were all good. i am happy its the passanger side, cause they drivers side takes an extra hour each time i take it out. i am going ot try to re-alighn the controll arms, and if not, im gonna fab a spacer to fit between the spring seat and the shock brace.
Thread
Thread Starter
Forum
Replies
Last Post
jeff94z28
Site Help and Suggestions
2
09-11-2002 02:01 PM