SCREWED car up again...what do you think??
#1
SCREWED car up again...what do you think??
K guys... I hanged a turn and hit a curb. Dented both ZR-1 rims on the passenger side along with trashing new Goodyear GS D3's. This is my problem. I put back on the original tires and now ...well I know the alignment is off, the passenger tire faces ******ds. But the problem is that it looks like the passenger side of the car sits lower than the drivers side (if looking from back or front). I even measured it and its like a half in shorter on the passenger side rear. It also looks as if the tires are set a lil further back on the passenger side front and back.
I was only going like 10 to 15 mph. I'm wondering what kind a damage I also have. I'm sure I aint the first to do this so any comments would definately be appreciated.
thanks.
I was only going like 10 to 15 mph. I'm wondering what kind a damage I also have. I'm sure I aint the first to do this so any comments would definately be appreciated.
thanks.
#5
Re: SCREWED car up again...what do you think??
Originally Posted by ROLYZ28
sorry bubba
just given CAPTAIN S.J.S my sad story..
never even checked the forum i was replying in
just given CAPTAIN S.J.S my sad story..
never even checked the forum i was replying in
#7
Re: SCREWED car up again...what do you think??
Originally Posted by Injuneer
Incorrect forum.... does not belong on "LT1 Engine Tech"
#8
Re: SCREWED car up again...what do you think??
no no no they cancelled the wheels and tires forum a long time ago!!
ever since the chinese took over the world production of wheels and tires
ever since the chinese took over the world production of wheels and tires
Last edited by ROLYZ28; 08-05-2004 at 02:45 AM. Reason: spelling
Thread
Thread Starter
Forum
Replies
Last Post
mspennyhughes
South Atlantic
0
11-28-2014 03:22 PM
squarehead
General 1967-2002 F-Body Tech
0
11-21-2014 08:02 PM
LS1 RULZ
Car Audio and Electronics
10
08-11-2002 11:15 PM